Standard Features

Perfect fit for your power supply and case-

• 3.5" on tallest side (with rubber feet attached) 
• Enough clearance to fit a Pedal Power2 and most standard power supplies under the pedalboard

• Perfect height to fit in a pedal train classic case (or Mono case).

---

Easy cable access- 

• Multiple 3/4" slots cut into pedalboard deck for convenient cable access.

• The row of slots closest to the highest point of the board is 1/2" wide; perfect for most 1/4" cables and DC right angle barrel connectors . (PLEASE measure the width of your cable ends before ordering to assure they will fit).

---

Joinery that combines beauty and strength-

• In combining both beauty and strength we were the first pedalboard builder to use screw reinforced rabbet joints. The joints are first clamped with premium grade wood adhesive, then reinforced with screws to assure maximum strength (all screw holes are filled with matching hardwood plugs).

• Additionally, our pedalboard decks are supported by precisely carved out notches in the rails and joined with wood adhesive & screws. We prefer this extra step rather than simply using corner brackets to support the deck like most pedalboard builders.

Screw reinforced rabbet joints

Pedal deck supported by carved out notches in rails

---

Smooth Build- 

• Screws covered and smoothly hidden with matching hardwood.

• Rounded Edges/Sides. Beautiful clear coat finish. 

---

Recessed Power inlet-

• A convenient way to get power to your pedals.
• Comes with an attached power cable inside so you can easily connect your own power supply.

• We take the extra time to recess the IEC power inlets as well as the 1/4" jacks. 

Recessed IEC Inlet comes with attached cable inside to connect directly to your power supply.

---

High Quality Attention to Detail-

• Furniture quality that's built to last.
• Each pedalboard is constructed from hand-selected, high quality hardwood.

• Hours of detailed attention put into every pedalboard.

---

Surprisingly Light-

• Our pedalboards are very strong... yet light. The extra time we put into the joinery allows us to refrain from installing unnecessary hardware which can weigh down a pedalboard.​

---

Rubber Feet-

• Keep your pedalboard from sliding on the stage!

---

Customizations

Wood Options-

• Our pedalboards come standard with beautiful oak or ash wood.
• Other hardwoods are also available to choose from such as walnut, curly maple, red padauk, mahogany, zebra-wood, ash, white walnut, or cherry. 

Recessed Input/Output Jacks (add ons)-

• 1/4" solder-less locking jacks.
• XLR male or female.
• Illuminated rocker power switch.
• All 1/4" jacks, XLR jacks, and rocker switches are recessed.

Recessed jacks

Recessed Power inlet-

• Choose your power inlet, what side of the pedalboard you want it installed.
• Comes with an attached power cable inside so you can easily connect your own power supply.
• Not sure what time of power inlet or cable to select? Check out our FAQ page or shoot us an email. 

Recessed IEC with built in on/off switch

Carved hand grips-

• An optional add-on for those wanting handles

Carved out handles

Wood Options

---

Ash

---

Mahogany

---

White Walnut

---

Combinations

---

---

Oak

---

Curly Maple

---

Red Padauk

---

---

Walnut

---

Zebrawood

---

Cherry

---

Deck Options

Natural

Black